-
Ulrich Mors answered a question 1 year, 12 months ago
Hi Ulrich,
I´ll upload !
ULI
-
Ulrich Mors wrote a new item 2 years ago
Hi,
shot PDW700 XDCAM HD422 1920×1080 50i (mpg2) and need to sync it up via Tentacle Sync Studio.
Software crashes when importing xdcam footage – […]
-
Ulrich Mors answered a question 2 years, 5 months ago
HI Ulrich,
just received the IOS cable, Movie slate TC plugin is installed, cant receive TC though cabling seems right and Level is set to MIC.
Any idea?
ULi
-
Ulrich Mors answered a question 2 years, 5 months ago
OK , here comes Denecke TS3 internal TC vs. Tentacle TC:
Today I started the Denecke jammed to Tentacle, 25fps, room temperature.
Direct test was […]
-
Ulrich Mors answered a question 2 years, 6 months ago
Bestätigt. Fs7 und tentacles läuft gut!
-
Ulrich Mors answered a question 2 years, 6 months ago
Suoort team???
-
Ulrich Mors answered a question 2 years, 6 months ago
Fine with 2 Tentacles.
-
Ulrich Mors answered a question 2 years, 6 months ago
Short Result:
TS3 (tc 25fps) ran off internally 1 frame against Tentacle Unit after 4-6hrs.
Since the Tentacle is so small and energy efficient […]
-
Ulrich Mors changed their profile picture 2 years, 6 months ago
-
Ulrich Mors wrote a new item 2 years, 6 months ago
Hi,
how can I setup a different freerun TC Value in the Mac OS version?
(eg: TC: 10:00:00:00)
?
ULi
-
Ulrich Mors answered a question 2 years, 6 months ago
FS5 is always XAVC LongGOP – does the Software not support Long Gop Formats of XAVC perhaps?
ULI
-
Ulrich Mors answered a question 2 years, 6 months ago
Hi,
I hooked up the denecke TS3 via Tentacle to XLR with an XLR/TRS Adapter (not needed if you go straight to TRS).
Works perfectly.
I am just […]
-
Ulrich Mors wrote a new item 2 years, 11 months ago
Hi,
is there no way to move a clip to its original TC-Stamp on the timeline? Multicam is not an option.
Also “synchronize” doesnt help with multiple […]
-
Ulrich Mors became a registered member 2 years, 11 months ago
offline active 1 year, 12 months ago