The time code synchronized to the camera does not appear.
I am using several panasonic lumix DC-BGH1 cameras.
The settings of the DC-BGH1 camera are as follows.
– System Frequency : 59.94Hz(NTSC)
– Rec Quality : 1920×1080, 29.97p
– SDI output resolution : 1080p
And the multi-camera system configuration is as shown in the figure.
(Tentacle and camera are connected using BNC connector.)
The camera’s time code setting is set to FREE RUN, NDF, and TC IN.
When recording a camera with this configuration, the timecode does not match.
Am I testing the wrong way?
I want to know which part of the problem is occurring.
(When testing with another camera, Panasonic AG-HPX255EN with the same configuration,
We confirmed that the timecode matches exactly.)
There is no AJA C10DA splitter right now.
Therefore, only the test using the BNC T connector was conducted.
In previous tests, even if one Tentacle uses a T connector to insert a TC into the camera, the TC displayed on the two cameras was different.
I think it’s the DC-BGH1 camera, not the Tentacle.
When comparing File-TC, there seems to be no problem,
There seems to be a problem when the camera displays the TC on the screen via the SDI output.
I made an inquiry to Panasonic, but there is no answer yet.
Thank you very much for your answers to solve this problem.