Battery changed / voltage on battery same across switch / non functioning completely dead

TS-1 Revision 4.3

Changed battery; nothing. Test replacement and original battery for voltage both test good. Voltage appears same at switch solder points on board of unit that will not power on, unit will not go into charge with flashing light, unit is dead despite voltage on switch. Switch is operable, clicks nice and board is clean, no signs of any damage.

Not sure how far to go in to testing as I have a replacement battery already and little knowledge of circuit path. Is there a simple multimeter test you would recommend next?

Answered question
0

How to take that measure?

spacebar clicker

Answered question
0

Ensure that the replacement battery has an appropriate voltage level. Use the multimeter to measure the voltage across the battery terminals. Make sure it matches the required voltage for the device. Drift Boss

Answered question
0

This forum is a users-helping-users forum. It appears you have a defect, better contact TentacleSync directly.

Answered question