Pairing failed

825 viewsSoftwarenot-syncing pairing Syncing Issue

Hi!

Any solutions for this? I have Track E and just bought Sync E mk2 as well. But it seems that I can’t pair them at all. Both of them show up on the iPhone’s Tentacle Setup via Bluetooth. On the upper part of the screen, there’s a yellow banner that says: ‘Devices have to be synchronized.’

After hitting the sync button and performing a frame rate check, it starts syncing. It verifies the sync for a while, flashes the text ‘Timecode Cable unplugged’ on Sync E, continues verifying, and then returns to the starting point with the banner saying, ‘Devices have to be synchronized.’

All the firmware is up to date, including the mobile app.

I have tried this with every combination—cables on/off, red mode, green mode, and even syncing with cables only. But I haven’t had any success in pairing them.

Cheers!

Answered question
0

@ geometry dash scratch

Hello, I think you should check Bluetooth settings. On your iPhone, go to the Settings menu and navigate to Bluetooth settings. Make sure that Bluetooth is enabled and that both the Track E and Sync E mk2 devices are paired and connected properly. If they are connected but not pairing correctly within the app, try removing the devices from the Bluetooth settings and then pair them again.

Answered question