The time code synchronized to the camera does not appear.
I am using several panasonic lumix DC-BGH1 cameras.
The settings of the DC-BGH1 camera are as follows.
– System Frequency : 59.94Hz(NTSC)
– Rec Quality : 1920×1080, 29.97p
– SDI output resolution : 1080p
And the multi-camera system configuration is as shown in the figure.
(Tentacle and camera are connected using BNC connector.)
The camera’s time code setting is set to FREE RUN, NDF, and TC IN.
When recording a camera with this configuration, the timecode does not match.
Am I testing the wrong way?
I want to know which part of the problem is occurring.
(When testing with another camera, Panasonic AG-HPX255EN with the same configuration,
We confirmed that the timecode matches exactly.)
a synced tentacle, either synced by bluetooth or wire, is absolutely within a frame. Maybe after 24 hours it can be off but my Tentacles battery stay within 1/10th of a frame sync.
I think it must be somewhere in the camera but i don’t know where. As a test, you can always use hard wired BNC timecode with Y splitters. Just to rule out a problem with tentacles.
They are on the same frame rate?