GMLee | Answers

There is additional confirmation. Except for the ATEM 8K switch in the configuration shown in the picture in the question, Decklink and the camera were directly connected. When checking the TC value...

There is no AJA C10DA splitter right now. Therefore, only the test using the BNC T connector was conducted. In previous tests, even if one Tentacle uses a T connector to insert a TC into the camera,...

Images used for synchronization analysis are saved directly from the camera to the SD card. When I checked File-TC using Premire pro and TTS, I was shooting the same screen with the same timecode. The...

Video recording of two cameras was simultaneously recorded using the "LUMIX Tether for Multicam" program by connecting the Ethernet line. (However, as a result of checking File-TC, there was a difference...

Sorry (T^T), I didn't understand the answer well because I didn't have basic knowledge about TC and video. Insert the TC into the camera using a BNC cable, Do you mean that if you record in this state,...

Not long after the camera was released, the firmware version is the same as one. Other cameras have confirmed that there is no problem, and I am convinced that the problem is with the BGH1 camera I am...

The frame rate of multiple cameras and Tentacle is the same with 29.97 settings. I tried inputting the timecode from one Tentacle sync E to two cameras using the BNC T connector. However, the timecode...

Thanks for your answer. I'm sorry not to upload images just by expanding the time of code. "Did you try to record all camera's filming this 'stopwatch' and see if the problem is then still there?" I didn't...